Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen PDF herunterladen (Seite 51)

Express 125/250 User Manual, v.3.1 37

Creating a custom patch

The console's custom patching capability allows you to create virtually any

dimmer to channel configuration you like. (Groups of dimmers may be

assigned to single channels, but only one channel may be patched to a

dimmer.)

Hint: If you use the same patch for several shows, create the patch, and

record it on a disk before you record any cues. Label the disk

Standard

patch

. When you start your next show, read the Standard patch show into

the console, then begin writing cues to avoid reentering the patch.

Follow these steps to patch dimmers to control channels.

Keystrokes: Action:

1. Press [Patch]. Selects Patch display

2. Press [Dim]. (If the LED in

the [Dim] key is lit, you

may omit this step.)

3. Use the keypad to enter

the numbers of the

dimmers you want to

patch. Use [And], [Thru] or

[Except] for multiple

selections.

a. For a dimmer set to Dimmer Double, press [S2],

, or [S3],

after entering the dimmer number. If you select a doubled

dimmer without specifying A or B, the selection defaults to A.

Prompt reads:

Select dimmer numbers, then press

ENTER to assign to a channel, or

press AT to assign a proportion, or

press PROFILE to assign a profile

4. Press [Enter] or [Channel]. Prompt reads:

To assign dimmers, select channel

number, then press ENTER

To delete dimmers, press UNPATCH

5. Enter the channel number

to which you want to patch

the selected dimmers and

press [Enter].

Dimmer(s) are patched to the channel

6. Repeat steps 2 through 4

to patch additional

dimmers.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 379 380

Kommentare zu diesen Handbüchern

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen Seite 51

Kommentare zu diesen Handbüchern