Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen PDF herunterladen (Seite 335)

Express 125/250 User Manual, v.3.1 321

Characteristics of the display

The display contains the following three elements: (1) the title line, (2) an

inventory of network devices, and (3) the Remote Units list. The title line

names the display and identifies the version of code on the diskette you

used to bring up the display (the upgrade diskette). The device inventory,

located below the title line, identifies all possible ETC network interface

devices by type, version number and CRC number. For a device in your

network to be compatible with the code on the upgrade diskette, both the

version number and the CRC number must match.

Your console will detect remote interface devices operating on your

network by listing them in the Remote Units list. From this list, you can

make the following determinations.

• Are any interface devices in your network not showing up in the list?

• Does every device in your network display a software version that

matches the version for that type in the device inventory?

• Does every device in your list display a CRC number that matches the

CRC number for that type in the device inventory?

Devices missing from the Remote Units list

There can be several problems preventing an interface device from

showing up on the Remote Units list, most of which are easily correctable.

First of all, verify power to a missing device as well as to the hub to which

it is connected, if any. Second, verify all network connections along the

network route along between the console and the missing device. If your

network uses twisted pair wiring, press [S6], Swap Twst Pair, and wait

ten seconds. If a missing device is an ETCNet2 node, set the protocol to

ETCNet by pressing [S5], Discover Nodes, and wait ten seconds. If all

efforts fail, see Help from ETC Technical Services, page 11, for

information about getting technical assistance.

Incorrect version or CRC number

If one or more devices on your Remote Units list does not show the

correct version or CRC number, perform a software upgrade for that

device. You have three options.

• Upgrade one unit

Use the console’s arrow keys to move the cursor to the unit. Press

[S3], Update This Unit.

• Upgrade some units

Use the console’s arrow keys to move the cursor to a unit you want

upgraded. Press [S8], Mark This Unit, to select that unit. If you want

to upgrade others at the same time, repeat this marking procedure for

each unit. An M will appear in the lines of marked units. When finished

marking, press [S2], Update Marked, to upgrade the marked units.

• Upgrade all units

Press [S1], Update All Units, to download to all remote units at once.

While code is loading to a remote unit, the percent completion for that unit

is shown in the display’s Status column. When the word Pass appears,

the upgrade for that unit is complete.

NOTE

: It is normal for software to load faster to an ETCNet2 device than

to a Remote Interface Unit or to a Remote Video Interface device.

Finish

1. Remove the Remote Unit Upgrade disk from the console disk drive.

2. Turn the console off.

1 2 ... 330 331 332 333 334 335 336 337 338 339 340 ... 379 380

Kommentare zu diesen Handbüchern

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen Seite 335

Kommentare zu diesen Handbüchern