Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen PDF herunterladen (Seite 145)

Express 125/250 User Manual, v.3.1 131

Recording a group using Solo

You can use Solo to selectively record into a group in the same manner as

using Solo to selectively record into a cue. There are two ways to select

channels with Solo: while clearing other independent channels such as

other lights and while clearing ALL other channels, including non-

independent ones. See Recording a cue using Solo, page 92, for the

procedures to use, substituting the [Group] key where those procedures

specify the [Cue] key.

Working with groups in Blind

There are two modes of operation in Blind for changing groups—Group

mode and Group Editing mode. In Group mode, the console brings up the

channels from a group of your choice and allows you to use them to

modify cues, submasters and other groups. In Group Editing mode, the

console allows you to create or edit the group itself.

Group mode

You enter Group mode in Blind by specifying a level after identifying the

group. The level is applied proportionally to all channels in the group.

Follow the procedure below to work in Group mode.

Keystrokes: Action:

1. Press [Blind]. Selects Blind display mode

2. Press [Group] [1]. Selects group 1’s channels

Prompt reads:

Group mode – To recall a group,

select the number and set it to a

level

To create or modify a group, select

the number and press ENTER

3. Press [At] [7][5]. Sets the channels to 75 percent of their

recorded levels

Prompt reads: Group mode – Press

AT or use wheel or trackpad to alter

levels, or select channel numbers to

edit

4. Press [Record] [Cue] [3]

[Enter].

Records the current level settings as

cue 3

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 379 380

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen Seite 145