Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen PDF herunterladen (Seite 143)

10 Storing and Using Presets 129

Editing Presets Live

There are two ways to edit a preset in Live. You may rerecord the preset or you may use [Update].

Rerecord

Rerecording follows the conventions of [Record] and [Record Only]. The only exception is that a

confirmation is required to actually rerecord the preset.

For Example:

Preset 5 has already been recorded. To rerecord Preset 5, recall the preset:

• [Preset] [5] [Enter]

Adjust parameters as needed. You may also adjust the parameters of previously excluded

channels in order to add them to the preset. When you are done, rerecord the preset.

• [Record] [Preset] [5] [Enter] [Enter]

Update

[Update] is used to record parameter modifications back to a preset. When updating, you must

specify the preset to be updated. You may do this using the keypad or the direct selects.

For the purposes of the following descriptions, assume that there are no active cues on stage.

Updating referenced values while cues are active is covered in Modifying Cues Live, page 149.

For Example:

To update a preset, first recall the preset for any channels you wish to edit

• [1] [Thru] [5] [Preset] [1] [Enter]

Make required changes to the desired parameters using the keypad or encoders. Once you

have achieved the desired look, update the preset.

• [Update] [Preset] [1] [Enter]

• [Update] & {Preset 1}

Unless you specify certain channels to be included in the update, all channels with manual data will

be included.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 337 338

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Spezifikationen Seite 143