Electronic Theatre Controls Emphasis Lighting Control System Bedienungsanleitung PDF herunterladen (Seite 224)

214 Emphasis Console v2.0.0 User Manual

MIDI Show Control

MIDI Show Control is a specific set of instructions that can be transmitted over a MIDI line

to control lighting systems and other controllers.

MIDI Show Control (MSC) Commands

Emphasis can receive MSC information, send MSC information, or both. You need to set

device IDs for the receiver device and the transmitter device.

Configure device IDs for MIDI Show Control:

Step 1: Press [Setup] [2] [Enter] to select the Options Settings.

Step 2: Press [2] [Enter] to edit the MSC device IDs.

Step 3: Using the Facepanel numeric keypad, type the receiver device ID (between #0-

126) and press [Enter], or press [S1 - Disable MIDI].

Step 4: Using the Facepanel numeric keypad, type the transmitter device ID (between

#0-126) and press [Enter], or press [S1 - Disable MIDI].

When you enable MSC at your Facepanel, Emphasis will accept the MSC commands listed

below. MSC commands are executed as soon as they are received. In order to accept MSC

commands, the console’s receiver Device ID must match the target device ID for the MIDI

device sending the signals.

Go • If no cue number is sent, Go presses [A/B Go] on the

console. The next cue on the cue list runs in the A/B fader.

• If a cue number is sent, the specified cue runs on the A/B

fader.

• If a cue number is sent, and 2 is sent as the list entry, that

cue runs on the C/D fader.

•If cue 0 is sent, and 2 is sent as the list entry, the

command presses [C/D Go]. The pending cue runs in the

C/D fader. You may also press [A/B Go] by sending Go-

Cue 0-1.

Stop •The Stop command by itself holds all fades in both fader

pairs.

• If Stop is sent with a cue number and a list entry of 1, only

the cue running in the A/B fader holds.

• If Stop is sent with a cue number and a list entry of 2, only

the cue running in the C/D fader holds.

• The cue number field is ignored, but must be included if a

list entry is sent.

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 317 318

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Bedienungsanleitung Seite 224