Electronic Theatre Controls Emphasis Lighting Control System Bedienungsanleitung PDF herunterladen (Seite 146)

136 Emphasis Console v2.0.0 User Manual

Cues

Blind allows you to edit cues and cue attributes without affecting the stage output. This is

useful when you are in the middle of a rehearsal or performance and you need to make a

change. Blind also allows you to see more detailed information about cues that contain

multiple parts, effects or subroutines.

Edit cues in Blind:

Step 1: Press [Blind]. The Blind display defaults to cues.

Step 2: Press [x] [Enter] to select cue [x]. You can also use the [+] and [-] keys to

increment and decrement through the cue list.

Step 3: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 4: Set levels using the procedure described in Set Levels, page 89 and Moving

Light Control, page 95. “Not Recorded” will blink in the lower left corner of the

channel area.

Step 5: Press [Record] <Cue> <x> [Enter], where [x] is the target cue number.

Note:

When you edit cues, submasters, groups or focus points in Stage, Fader or Blind,

changes to channel levels or effects are not recorded until you press [Record] [Enter].

Changes to overall cue or submaster timing do not require [Record] [Enter].

Multi-Part cues

In Blind, you can view a multi-part cue as a whole, or by part. When viewing individual parts,

other channels recorded in the cue are displayed with grey levels. A channel may only be

recorded into one part of a multi-part cue.

Edit multi-part cues in Blind:

Step 1: Press [Blind]. The Blind display defaults to cues.

Step 2: Press [x] [Enter] to select cue [x]. You can also use the [+] and [-] keys to

increment and decrement through the cue list. The whole cue will be displayed

until you select a specific part to view or edit.

Step 3: Press [Part] [y] to select part [y]. You can also use the [+] and [-] keys to

increment and decrement through the parts.

Step 4: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 5: Set levels using the procedure described in Set Levels, page 89 and Moving

Light Control, page 95. “Not Recorded” will blink in the lower left corner of the

channel area.

Step 6: Press [Record] [Part] [y] [Enter], where [y] is the target part number.

Note:

Alternatively, you can press [Record] [Enter] to record modified levels back into their

source part. This way you can modify levels across the cue without having to edit each

part individually. Channels added to the cue will be recorded into part 8, unless you

specifically choose a part in the record command.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 317 318

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Bedienungsanleitung Seite 146