Electronic Theatre Controls Emphasis Lighting Control System Bedienungsanleitung PDF herunterladen (Seite 180)

170 Emphasis Console v2.0.0 User Manual

A/B and C/D Fader Pairs

Your Facepanel has two timed fader pairs, called the A/B and C/D fader pairs, that are used

to play back recorded cues. The left-hand fader in each pair controls the upfade, and the

right-hand fader controls the downfade of a crossfading cue.

You may play back cues using the recorded fade timing or by taking control of the fade

manually (see Manual control, page 174). You can also affect the speed of a cue using the

rate override feature (see Rate, page 175).

You may play back cues in order, or by calling up individual cues one at a time. You can

also have active cues in both fader pairs at the same time.

Fader Controls

Each fader pair has a dedicated set of controls. On Expression and Insight facepanels,

each fader pair has a set of LEDs that track the current completion level of crossfading

cues. These LEDs also indicate when the contents of the fader is a subroutine or effect.

Each fader pair has a [Go] key. When you press [Go], the next cue in the cue list will play

back in that fader pair. The “next cue” may be the next-higher cue number, or it may be

determined by a [Link] command in the current cue. Regardless of which fader pair you

chose to run a cue in, a [Go] press on either fader pair will play back the next cue.

Note:

If you alternate between A/B [Go] and C/D [Go], you will see the output of both fader

pairs (two cues) on stage at the same time. In general, if you want to crossfade from one

cue in the cue list, use only one [Go] key for playback.

Hold

The [Hold] key is found to the right of the [Go] key. When pressed, the [Hold] key pauses

the current fade and holds it at that level. To resume the fade, press [Go] on the same fader

pair.

If the [Hold] key is pressed twice, the current fade is cancelled at it’s stopping point. A [Go]

press after this cancellation causes the initial cue to be “skipped” and the next cue to play

back.

Back

The [Back] key is found above or to the side of the fader pair. The [Back] key causes the

playback to move backwards through the cue list. When you move backwards through the

cue list, cue link commands are ignored.

Rate

The [S5 - Rate] key is found above or to the side of the fader pair. When the [S5 - Rate]

key is pressed, the fade rate of the currently-fading cue can be altered using the rate wheel

or the trackpad. Once the current cue completes its fade, the rate control is released from

the fader.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 317 318

Keine Kommentare

Electronic Theatre Controls Emphasis Lighting Control System Bedienungsanleitung Seite 180