Electronic Theatre Controls Source Four Revolution Bedienungsanleitung PDF herunterladen (Seite 7)

Installing a lens

Step 1: Position the fixture with the front of the unit (lens side) facing you, and tilted slightly

upward. See Figure 9.

Step 2: Hold the lens by the edge and position it so the convex side faces the rear of the fixture.

Step 3: From the top of the fixture, slide the lens behind the lens catchers and position it behind

the tabs on the bottom of the lens rotator ring. Gently push the top of the lens inward until

it snaps behind the spring clip.

Cleaning glass lens and reflector

Cleaning glass lens

Replace lenses if they contain visible damage (cracks or deep scratches) that may impair their

effectiveness.

Remove dust with a blast of oil-free air or wipe with a clean, lint-free cloth. Isopropyl alcohol, distilled

water or a 50%-50% mixture of each can be used to clean the glass surface.

Cleaning the reflector

To quickly clean the reflector, remove the lens (See “Removing a lens” on page 4.) and clean the

dust from the reflector with a blast of oil-free air. You may also wipe the reflector with a clean lint-

free cloth. If either method is not sufficient, follow these steps.

Step 1: To protect the lamp housing during cleaning, remove the lamp housing by loosening the

knurled bolt and pulling the housing straight out. See Figure 3.

Step 2: Remove dust with a blast of oil-free air or wipe with a clean, lint-free cloth. Isopropyl

alcohol, distilled water or a 50%-50% mixture of each can be used to clean the glass

surface.

Step 3: Gently wipe the reflector.

Step 4: Perform the steps in Installing a lens, page 5.

Step 5: Reinstall the lamp housing and tighten the knurled bolt.

Note:

Installing the lens with the convex side out will not impair the optics, but it will make

removing the lens difficult.

WARNING:

Do not use ammonia-based or other harsh commercial cleaners. Clean lens

and reflector only as directed.

Commercially available glass cleaning agents should be avoided as they

may contain ammonia, other harsh chemical detergents or abrasive agents.

These cleaners may damage the glass surface and the Anti-Reflective

coatings. Do not immerse or soak the glass in any cleaning solution.

WARNING:

Unplug the fixture before attempting to clean the reflector.

Spring clip

Retaining clip

Lens Catcher

Spring clip

Retaining clip

Tab

Figure 7

Figure 8

Figure 9

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Electronic Theatre Controls Source Four Revolution Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Electronic Theatre Controls Source Four Revolution